Sunday, January 16, 2011

Updates to the Addition Plans.


The plans for the mother-in-law apartment are evolving.

I had intended to put a full basement under the apartment.  Because the apartment will butt up against portions of the  the existing foundation that are not full basement height, this has become a practical impossibility.  With the full basement off the table, my architect had two proposals.  One, to build the addition over a crawl space; or two, to pour an above grade concrete slab.  The concrete slab would forever embed any below floor mechanical stuff (drains, duct work) within it.  I have opted for the crawl space.

I have been thinking about an alternate use for the ground which will be below the addition; and am exploring the possibility of using that ground as a heat source / sink for a geothermal heating / cooling system for the addition.

A geothermal heating / cooling system is exactly like a regular heat pump system except that it uses the ground, instead of the atmosphere, and the source or sink for heat.  The ground, at a depth of 4 - 6 feet is a fairly constant temperature year round, around 55 degrees.  It is sort of obvious that using the ground, at 55 degrees, to dissipate the heat from your house would be a lot more efficient than trying to dump the heat into an atmosphere which is 80 - 90 - 100 degrees.  Not so obvious is the heating side of the equation until you realize that the dense ground at 55 degrees holds a lot more heat than winter air at 20 - 30 - 40 degrees.

The cooling side of a geothermal system is exactly like a regular air conditioning system except that the heat generated by compression of the coolant is dissipated into the ground instead of into the atmosphere.  Since the ground is already quite cool, the dissipation is much more efficient.  The ground will become warmer in the area of the dispersing coils, but that warmth will be dispersed.

When you switch to heating, the processes are reversed.  It is as if you are trying to cool down the ground by dissipating the heat in the ground into the house.  So you compress the coolant,  then cool it using the air in the house (in the process, the air in the house warms);  then you use the heat in the ground to re-expand the coolant.  The ground grows cooler for a while in the area of the expansion coils, but that soon dissipates into the vastness of the earth.

In a sense, during the summer, you are storing warmth in the ground which will be recaptured during the winter to heat the house; and in the winter you are storing coolness to be recovered in the summer.

It is really an electrical heating / cooling system.  Electricity is used to run the compressors, to circulate the coolant into the ground, and to circulate the air within the structure.

No comments: